Dog Beds | Beds for Dogs | Pet bed | PVC Dog Beds

Assembly Instructions

PVC DOG BEDS DIRECT
1065 E. STORY RD.
WINTER GARDEN, FL 34787
PH 407-656-0704
FAX 407-656-5641
E-MAIL pvcdmeds1@aol.com

ASSEMBLY INSTRUCTIONS FOR TIGHTENING SLING:

1) FOR EASIEST METHOD OF TIGHTENING SLING PUT A LITTLE BIT OF VASOLINE INSIDE THE CONNECTOR FITTINGS BEFORE INSERTING THE PIPES TO ASSEMBLE THE FRAME. THIS WILL ALLOW YOU TO ROLL THE PIPES AND TIGHTEN THE FABRIC.

2) ONCE THE TOP FRAME IS ASSEMBLED (USE THE POCKETS IN THE FABRIC TO SLIDE THE PIPES THROUGH), THEN SNAP THE SNAPS IN PLACE.

3) WITH THE FARIC SNAPPED TO THE PIPES AND THE TOP FRAME ASSEMBLED, ROLL THE LONG PIPES UNTIL THE SLING IS TIGHT AND INSERT THE SMALL SET SCREWS IN PLACE ON THE UNDER SIDE OF THE BED TO SECURE THE PIPES IN PLACE.

NOTE: THIS MAY TAKE 2 PEOPLE TO DO EFFECTIVELY.

THANK YOU!